The effect of metal work function on the barrier height of metal/CdS/SnO2/In-Ga structures


Tascioglu I., Altindal S., POLAT İ., BACAKSIZ E.

CURRENT APPLIED PHYSICS, cilt.13, sa.7, ss.1306-1310, 2013 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 13 Sayı: 7
  • Basım Tarihi: 2013
  • Doi Numarası: 10.1016/j.cap.2013.04.010
  • Dergi Adı: CURRENT APPLIED PHYSICS
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.1306-1310
  • Anahtar Kelimeler: Metal/CdS/SnO2/In-Ga structures, Barrier height dependence, Metal work function, Series resistance, SCHOTTKY DIODES, IV PLOT, CDS, FILMS, DEPENDENCE, CONTACT
  • Karadeniz Teknik Üniversitesi Adresli: Evet

Özet

In order to interpret the effect of metal work function on the formation of the barrier height at metal/semiconductor (M/S) interface, the CdS/SnO2/In-Ga structures with several metals (Ag, Au, Al, Te) have been investigated by using I-V characteristics at room temperature. The main electrical parameters such as ideality factor (n), zero-bias barrier height (Phi(Bo)), series resistance (R-S) have been determined and compared with each other. The values of n were found to be 3.00, 2.56, 3.83, and 3.31 for Al, Ag, Te, and Au/CdS/SnO2/In-Ga structures, respectively. The values of Phi(Bo) were also found to be 0.489 eV, 0.490 eV, 0.583 eV, 0.591 eV for Al, Ag, Te, and Au/CdS/SnO2/In-Ga structures, respectively. The Phi(Bo) dependence on the metal work function (Phi(m)) was found to vary almost linearly as Phi(Bo) = 0.106 Phi(m) + 0.028. The low value of the slope S (d Phi(B)/d Phi(M) congruent to 0.106) shows a weak relationship between Phi(Bo) and Phi(m) due to serious Fermi-level pinning in the conduction band. In addition, the I-V plots have a rectifying behavior. The rectification ratio, defined by the ratio of forward to reverse current (RR = I-F/I-R) measured at the same absolute bias, was found as 11.96, 20.88, 35.82, and 75.61 for Al, Ag, Te, Au/CdS/SnO2/In-Ga diodes, respectively. In addition, the values of R-S were determined from Ohm's Law and Norde's method. Analysis of I-V characteristics confirm that using of different metal (Al, Ag, Te, Au) has significant effect on electrical parameters of such devices. Crown Copyright (C) 2013 Published by Elsevier B. V. All rights reserved.