Polymers, vol.17, no.1, 2025 (SCI-Expanded)
The introduction of 3D printing technology has broadened manufacturing possibilities, allowing the production of complex cellular geometries, including auxetic and curved plane structures, beyond the standard honeycomb patterns in sandwich composite materials. In this study, the effects of cell design parameters, such as cell geometry (honeycomb and auxetic) and cell size (cell thickness and width), are examined on acrylonitrile butadiene styrene (ABS) core materials produced using fusion deposition modeling (FDM). They are produced as a result of the epoxy bonding of carbon epoxy prepreg composite materials to the surfaces of core materials. Increasing the wall thickness from 0.6 mm to 1 mm doubled the elastic modulus of the re-entrant structures (5 GPa to 10 GPa) and improved compressive strength by 50–60% for both geometries. In contrast, increasing cell size from 6 mm to 10 mm significantly reduced compressive strength by 80% (from 2.5–2.8 MPa to 0.5–0.6 MPa) and elastic modulus by 70–78% (from 9–10 GPa to 2–3 GPa). Flexural testing showed that the re-entrant cores, with a maximum load capacity of 148 N, exhibited more uniform deformation, while the honeycomb cores achieved a higher load capacity of 273 N but were prone to localized failures. These findings emphasize the directional anisotropy and specific advantages of auxetic and honeycomb designs, offering valuable insights for lightweight, high-strength structural applications.