MICROSTRUCTURAL AND MICROHARDNESS CHARACTERIZATION OF TIO₂-COATED AISI 431 MARTENSITIC STAINLESS STEEL PRODUCED BY RF MAGNETRON SPUTTERING
16th International Azerbaijan Congress on Life, Engineering, Mathematical, and Applied Sciences |, Baku, Azerbaycan, 20 - 22 Eylül 2026, ss.193-202, (Tam Metin Bildiri)
- Yayın Türü: Bildiri / Tam Metin Bildiri
- Basıldığı Şehir: Baku
- Basıldığı Ülke: Azerbaycan
- Sayfa Sayıları: ss.193-202
- Karadeniz Teknik Üniversitesi Adresli: Evet
Özet
Surface engineering through physical vapor deposition (PVD) provides an effective route for tailoring the near-surface microstructural and mechanical characteristics of martensitic stainless steels without altering their bulk properties. In the present study, a titanium dioxide (TiO₂) coating was deposited onto AISI 431 martensitic stainless steel by radio-frequency (RF) magnetron sputtering, and the resulting microstructural characteristics, coating architecture, and surface microhardness were systematically evaluated. The specimen coated for 90 min was designated as Ti-90 throughout this study. Prior to deposition, rectangular prismatic AISI 431 stainless-steel specimens produced by machining were ultrasonically cleaned in an alcohol medium to remove surface contaminants and residual impurities. TiO₂ deposition was subsequently conducted at a base pressure of 3 × 10⁻⁶ Torr and a working pressure of 15 mTorr, with the substrate maintained at 300 °C. The process was performed using an RF power of 120 W, an argon flow rate of 200 sccm, a rotational speed of 20 rpm, and a deposition duration of 90 min. The microstructural characteristics of Ti-90 were examined by scanning electron microscopy (SEM). Low-magnification observations at 250× revealed that the pre-existing grinding traces remained discernible following deposition, while the TiO₂ layer uniformly covered the substrate surface. No pronounced cracking, delamination, or macroscopic coating discontinuities were detected. At higher magnification (10,000×), the deposited layer exhibited a fine-grained, compact, and comparatively homogeneous morphology, accompanied by a limited number of small surface particulates that did not compromise the overall continuity of the coating. Cross-sectional SEM characterization further demonstrated a clearly distinguishable coating/substrate interface and continuous coverage across the investigated region. The TiO₂ coating thickness was measured at approximately 4.83 μm at 2500×magnification, confirming the formation of a well-developed micrometre-scale surface layer after 90 min of RF sputtering. Surface mechanical performance was assessed by Vickers microhardness testing under an HV0.1 load (100 g) with a 15 s dwell time, using three independent measurements. The uncoated reference surface exhibited an average hardness of 265.67 HV0.1, whereas Ti-90 reached 300.67 HV0.1, with individual measurements of 317, 271, and 314 HV0.1. These results demonstrate that the compact and continuous TiO₂ layer produced by RF magnetron sputtering provides a measurable enhancement in near-surface hardness while maintaining a structurally coherent coating morphology. Overall, the Ti-90 condition demonstrates the effectiveness of controlled TiO₂ deposition for simultaneously modifying the microstructural architecture and surface mechanical response of AISI 431 martensitic stainless steel.